How you use your tools is just as important as what tool you choose for a specific application. Look here for field proven ways to work smarter, faster and safer.
The closer the twists are to your contacts, the better the performance. So don't just push your twists, BUT push & pull. Take advantage of those extended conductors & watch your performance go up!
Cutting large diameter cables like 750 MCM can be a bear on your hand! Use the cutting boot to provide a stable platform for the cutter. Now you can put your weight behind the moving blade to improve your leverage... and save your hand!
Tired of pulling the braid back over your coax cable jacket and getting little pieces of braid in your fingers?
Do it the EZ way! Cut a small piece of Velcro, the 'prickly' side, and stick it on the side of your coax stripper. You now have a comb to brush back the braid over the jacket. You will be happy with how nice and even the braid looks and your fingers will be happy too!
Pushing an F connector onto RG6 QUAD coax cable can be a real bear, BUT don't despair. Combine these two tools to make it EZ!
1. Use the EZ-GRIP Puck for holding & gripping the cable.
2. Thread the connector onto the F Connector Assembly Removal Tool.
When stripping coax, do not turn your tool around as though it were a propeller.
As you rotate your tool, listen to the cutting of the braid and when it stops talking to you, turn another 1/8 to a 1/4 turn, open tool and remove the stripper. When rotating, be sure the hand that is holding the cable is supporting the cable immediately next to the tool. Allow no cable play!
When using your Cat5 Cable Jacket Stripper, do not rotate it around & around & around. You want to score the jacket, not cut through it. Then remove the tool, and slightly bend the cable where it is scored and it will 'pop' and separate, viola! This way you will know for sure you have 'no' nicks on the conductors.
What do you do with the small piece of twisted pair cable jacket when you remove it, exposing the 4 pairs to prep for terminating?
Don't throw it away! It's a free tool & handy too. You can use it to separate the individual wire pairs by simply pushing and turning at the same time. Be sure to turn in the opposite direction of the twist and open up each pair end down to the cable jacket. For a professional version of your free tool, separator, take your scissors and cut jacket at an angle!
Copyright © 2014 Platinum Tools®. All Rights ReservedFollow Us